TheraFace Mask Glo

1. Charge the device before use.
2. Begin with a clean, dry face. Do not allow the device to come in contact with colored solids or liquids, as it is hard to clean after being dyed. Remove all makeup, wash hands thoroughly, and ensure that cosmetics (such as lipstick) and oils do not come into contact with the device.
3. Place the device on your face, and adjust both of the Velcro straps to your desired fit. The device should feel snug but not too tight on your face.
4. Press and hold the LED power button to begin a light and vibration treatment. Press and hold the vibration power button to turn on the vibration treatment only. At any point during the light and vibration treatment, press and hold the vibration button to turn off the vibration for light treatment only.
5. Select your desired LED light treatment setting. The device will guide you through a 12-minute science-backed treatment that automatically cycles through three LED light treatment types: red light, red + infrared light, and blue light. Each treatment will be 4 minutes long. Press the LED power button at any point to cycle through light therapy types. You will hear a beep when the light therapy type changes.
6. Select your desired vibration treatment setting. There are two vibrating motors located in the headstrap. Press the vibration button to toggle through the three vibration modes (Relax: low-frequency continuous; Refresh: higher-frequency continuous; and Relieve: wave). Use vibration as a standalone treatment without LED light by pressing and holding the LED button while vibration is on. If vibration is used as a standalone treatment, it will run for 12 minutes.
7. Turn off the device. Press and hold the power button at any point during the treatment to turn off the device. The LED light will turn off when the device is off. The device will automatically shut off after the 12-minute treatment is complete. *This device has built-in eyeshields. Normal use of the eyeshields may result in redness around your eye area. Some redness is normal and should subside within 5-10 minutes of using the device

Before using or charging, read all instructions and cautionary markings in this manual, on the charger.

Materials
Silk print on housing and strap.
Vibration Motor: Steel & Aluminum
Shields: Medical-Grade Silicone


80% of participants reported improvements in fine lines*
87% of participants reported their skin looks and feels smoother*
87% of participants reported their skin looks and feels tighter*
86% of participants reported their skin feels more radiant and rejuvenated*

*12-week clinical study with 104 subjects and 1x/day use of pre-programmed 12-min treatment. Individual results may vary.

How do I clean the device?
Before cleaning, turn off the device. Ensure that the device is not connected to a charging cable or a power source before cleaning.

The TheraFace Mask Glo is not waterproof. Do not submerge the device in water or apply excessive cleaning solutions.

Wipe off any visible dirt with a disposable cloth moistened with a mild detergent. Be sure to wipe the interior surfaces of the mask.

Next, use a soft cloth dampened with 70% isopropyl alcohol to wipe and disinfect the mask for three (3) minutes, especially the inner surface of the mask. Repeat this process three times. Finally, wipe the disinfectant with a clean, dry cloth or towel until there is no visible residue.

After cleaning, allow the device to dry thoroughly before storing or beginning another treatment.

For best hygiene practice, clean the device after every use.

What is the battery life?
Approximately 60 minutes (12-minute routine with vibration)